Instruction manual for inductance wire drawing machine
(JT32M type)
1、 Preface
JT32M Inductive Pulling Machine; A device for removing wires and pressing feet for magnetic ring inductors and transformer pins; This model is designed specifically for various types of magnetic ring and transformer types, and is commonly used for magnetic ring transformers with wire diameters below 0.6MM. This model provides the ability to complete the work of disconnecting, pressing feet, and correcting wire packages, with the entire process completed in 0.5 seconds; A wire drawing equipment with high processing efficiency, good product quality, and reduced labor costs. Due to its stable equipment and wide adaptability, it is loved by the circular inductor processing industry.
2、 Main features
◆: Overall compact and compact, the panel is made of top-notch steel material, with a surface electroplated and hardened treatment, and a well-designed design; Designed in accordance with ergonomics, hands will not feel tired after prolonged operation; The chassis is sprayed with Chinese red baking paint for a more beautiful appearance;
◆: The product outlet adopts a telescopic structure. Protect work from injuring hands. Safer operation;
◆: Design a pressure adjustment knob to adjust the pressure on different types of magnetic ring bases without damaging the skeleton:
◆: Using high-quality finger cylinders, PLC computer control, stable operation and fast speed;
◆: Wide compatibility, both magnetic rings and transformers can be used;
◆: Using a regular 0.8mpa air compressor air source. 220V power input.
3、 Installation instructions
4、 Function Description
1: Power switch;
2: Start button: Start switch, press to automatically complete the entire action, just like the foot switch function;
3: Manual feeding: For manual feeding, press the feeding cylinder once to feed and then press it again to reset;
4: Manual pressing down: Press the cylinder once to press down, then press to reset;
5: Manual wire clamping: jog the wire clamping cylinder once to clamp, then press to reset;
6: Manual wire pulling: jog the wire clamping cylinder once to retract, then press to reset;
7: Wire clamping cylinder:
8: Width adjustment: Adjust the distance between the two wire clamping cylinders, adjust according to the product width, and achieve the maximum product width
35MM, special products can be customized with clamp widening width. (Loosen the cap on the bolt first when adjusting)
9: Lower pressing top column: The height can be adjusted through the "Lower pressing height adjustment bolt";
10: Pressure adjustment knob: used for pressing wire heads, to adjust the downward pressure of the top column to ensure that the wire head is not too high.
11: Fixture height adjustment bolt: Adjust the height between the end of the line and the clamp, generally 1-2mm lower than the midpoint of the clamp. Note: If the switch is pressed improperly, the start button or foot pedal does not work, turn off the power to reset it
5、 Replace the fixture
1: First, turn off the power. Loosen the fixture bolts, take out the fixture and replace it with the required fixture;
2: If necessary, some products may be wider or smaller products may have shorter thread ends. Please adjust the width bolt appropriately.
3: According to the height of the product, if necessary, adjust the height of the down pressing column appropriately.